Design to install
Design it. Engineer it. Build it.
Structural steel fabrication and precision engineering, based in Timaru, New Zealand.
The studio
Design and engineering, under one roof — no handover between them.
Most fabrication work stalls at the handover between the drawing and the shop floor. RBR runs both under one roof: the same team that models a part is the one that proves it will hold its load, then cuts, welds, and finishes it to spec. Recent work includes structural steelwork, security cages, bollards, and stainless fittings for commercial fitouts around Timaru.
How a job runs
01
Brief
Site survey, load requirements, material spec, and the standard the job has to certify against
02
Design
Every part modelled and checked against its load case before anything is cut
03
Fabricate
Cutting, forming, and welding, done in-house against the drawing set
04
Finish
Galvanizing, powder coat, or raw mill finish, matched to the environment
05
Install
Delivered and installed to spec, snagged and signed off on-site
Prefer the full story? Watch the scroll tour — or see what we do.